You are viewing a single comment's thread.

view the rest of the comments →

0
1

[–] 13JFO 0 points 1 point (+1|-0) ago 

(was a lurker, decided to hop in) This is a good summary man, there should also be a guide that lists some of the jigs, drill presses, and mini-mills available for cutting and drilling. Tooling can get expensive.

0
1

[–] clamhurt_legbeard [S] 0 points 1 point (+1|-0) ago 

0
1

[–] 13JFO 0 points 1 point (+1|-0) ago 

Nice man. I've finished an 80% before for a pistol build, used a jig. I tried using a drill press with a milling jig one time and did plunge cuts. But the floor turned out a little gross in the receiver's main cavity. I'm debating investing in a mini-mill for doing it again and might try to do a form 1 supressor build.