0
1

[–] carlip 0 points 1 points (+1|-0) ago 

did you mean for the front end to be slightly lifted? it doesn't look even but it's hard to tell from one picture.

0
0

[–] winewhisperer [S] 0 points 0 points (+0|-0) ago 

Yes, it is about 5 degrees from the plane that is parallel to the table. The frame is only about 50% completed. That was more of an aesthetic decision than anything from our frame designer. Should look amazing when it's done.

0
1

[–] carlip 0 points 1 points (+1|-0) ago 

well just remember to subtract .125-.1875 per bend inches to the length of the rest of the roll cage bars, if you're getting the formed. I assume you're not using really thick tubing so it will "stretch" if formed.

0
1

[–] winewhisperer [S] 0 points 1 points (+1|-0) ago 

As part of the SAE Baja Student Design Series. We're a group of engineering students who design and built off-road vehicles from the ground up.