You are viewing a single comment's thread.

view the rest of the comments →

0
2

[–] HAESSnowflake 0 points 2 points (+2|-0) ago 

Did you change the flex hose on that side? If the hose is collapsed internally the caliper will not work.

0
1

[–] theoldguy 0 points 1 points (+1|-0) ago 

In my experience, the collapsed hose will apply the brake fine, as the brake line pressure on application is high enough to force its way through, but it won't release, causing a pull to one side and uneven wear. This also applies to the ungreased slides mentioned below.

0
1

[–] P8rtsUnkn0wn 0 points 1 points (+1|-0) ago 

Flex hose should be fine. If it was pinched, would I had been able to bleed that side?

0
1

[–] WiLiV [S] 0 points 1 points (+1|-0) ago 

If the flex hose is totally blocked, no fluid would reach the caliper. I suspect your caliper or the slide pins have seized. Get this fixed soon, because the first time you make a buttpucker stop, the uneven braking action will pull you right off the road.

0
0

[–] Cat-hax 0 points 0 points (+0|-0) ago 

I had this problem, I thought it was the caliper so I replaced them, then the left side break locked up coming to a slow stop at a toll booth, I said fuck that and replaced both lines, breaks work perfectly now, after spending just about 1000$ on replacing the calipers twice over a 15$ line. Sigh.