[–] ForeverAlways 1 point -1 points (+0|-1) ago 

Most commercial cnc programs are 5000-20000 lines long, by the way. Homebrew cnc is only 200-500 lines long. But then you buy cnc programs rather than write your own b-list shit.

[–] DC92T 0 points 1 point (+1|-0) ago 

Being a machinist myself I completely understand your analogy. It should be open sourced, it should be tested and verified again and again. November 3rd decides which way our country goes and should be treated as important as it is...

[–] NiggadermCQ ago 

Check the defcon videos. Voting machines hacked in minutes. Sometimes by a teen.

[–] Killnigs3 ago 

10000% every step pf every process needs to be public open and auditable inc ln uding the machines the circuit boards the facilities where they are produced should also be open to audit and video surveillance. everything ahould be under watch we have the technology to make things truly transparent that we dont is proof nothing more than of fraud.

the truth fears no investigation.

[–] Maskancan 1 point -1 points (+0|-1) ago 

lol Cry me a riverrrrrrrrrr

[–] thebearfromstartrack ago  (edited ago)

This code was WRITTEN by INDIANS (from India), I GUARANTEE it. NO witnesses will come forward. ANY key personal already back in India are on NEW assignments with BETTER pay and of course NONDISCLOSURE agreements, except they will KILL THEIR FAMILIES in INDIA if the squeal.

[–] whatisbestinlife 1 point -1 points (+0|-1) ago 

this proves that house republicans are useless. it would appear that the only way you get good machines is to burn down the old machines and continue until good ones show up.

[–] Amerikaner 0 points 3 points (+3|-0) ago 

As a software engineer I’m sure you’re aware of the verification and validation process, and how it’s applied to software development. With something as quantifiable during testing as the number of correct vs incorrect votes, it’s inconceivable that this is not intentional.

load more comments ▼ (46 remaining)