[–] thebearfromstartrack ago  (edited ago)

This code was WRITTEN by INDIANS (from India), I GUARANTEE it. NO witnesses will come forward. ANY key personal already back in India are on NEW assignments with BETTER pay and of course NONDISCLOSURE agreements, except they will KILL THEIR FAMILIES in INDIA if the squeal.

[–] Maskancan 1 point -1 points (+0|-1) ago 

lol Cry me a riverrrrrrrrrr

[–] Killnigs3 ago 

10000% every step pf every process needs to be public open and auditable inc ln uding the machines the circuit boards the facilities where they are produced should also be open to audit and video surveillance. everything ahould be under watch we have the technology to make things truly transparent that we dont is proof nothing more than of fraud.

the truth fears no investigation.

[–] NiggadermCQ ago 

Check the defcon videos. Voting machines hacked in minutes. Sometimes by a teen.

[–] DC92T 0 points 1 point (+1|-0) ago 

Being a machinist myself I completely understand your analogy. It should be open sourced, it should be tested and verified again and again. November 3rd decides which way our country goes and should be treated as important as it is...

[–] ForeverAlways 1 point -1 points (+0|-1) ago 

Most commercial cnc programs are 5000-20000 lines long, by the way. Homebrew cnc is only 200-500 lines long. But then you buy cnc programs rather than write your own b-list shit.

[–] Nigger_Loving_Jew ago 

Even if the voting software were open source how would you know that the binaries used in the machines was compiled form the same code?

[–] Broc_Lia 0 points 1 point (+1|-0) ago 

I can't think of an honest reason why polling software shouldn't be that simple.

load more comments ▼ (6 remaining)