0
4

[–] Pointyball 0 points 4 points (+4|-0) ago 

The answer is usually no. If you twist multiple neutrals together in the panel and then bond the pigtail to the ground bar most inspectors will fail the permit.

0
3

[–] MrPim 0 points 3 points (+3|-0) ago 

Do not overload your nuts.

0
1

[–] QualityShitposter [S] 0 points 1 point (+1|-0) ago 

Good point in shitpost format. Will add in a secondary buss bar.

0
1

[–] VanilluhGorilluh 0 points 1 point (+1|-0) ago 

Better check your code for your state, but I've doubled up on a panel for a commercial building before and passed Inspection.

0
0

[–] QualityShitposter [S] ago 

Trying to sell and the buyers inspector flagged it. I assume it passed inspection at one point, but fussy buyers are fussy buyers.

0
1

[–] Pointyball 0 points 1 point (+1|-0) ago 

It wasn’t good work. They needed to add another ground bus bar, but it is a much bigger job than simply adding a circuit. That is why they pigtailed the neutrals. If they were smarter, they would have pigtailed a few grounds and bonded that to the bar. The current normally flows through the neutral so the load on the ground is negligible if anything.

0
0

[–] auchtung ago 

A wise man once told me "If you have to ask, then no"

0
0

[–] QualityShitposter [S] ago 

Would you like a beer?

0
0

[–] auchtung ago 

Lol, cheeky fuck.

0
0

[–] CarpenterforChrist ago 

Sure. Just make sure you're not overloading the circuit. If you think it may be close, add another breaker.