0
0

[–] ShinyVoater ago 

I haven't had an issue with it yet on any of my devices. Make sure to put the cables in and take them out as straight as possible.

0
1

[–] TigoleBitties 0 points 1 point (+1|-0) ago 

USB C is the best answer. Larger and more stable connector, higher power and higher speed. Only downside is cheap cables can really be a pain.

0
0

[–] 13117916? ago 

I like wireless charging for this very reason. My previous phone was rarely ever plugged into anything. I hate that my current one doesn't. My next phone will have wireless charging.

1
-1

[–] WORF_MOTORBOATS_TROI 1 point -1 points (+0|-1) ago 

Same, chargers too.

0
1

[–] stradian 0 points 1 point (+1|-0) ago  (edited ago)

Charging ports can be easily fixed. Even microusb, if you have a magnifing glass, flux, wick, a decent iron with a SMD-able tip, good solder, and a steady hand. All microusb receptacles are standardized in the USB standards document.

0
0

[–] kalchaya ago 

Pretty much everything is designed to have a short life......it's called ~ https://en.wikipedia.org/wiki/Planned_obsolescence. And here: https://www.youtube.com/watch?v=wzJI8gfpu5Y

0
0

[–] 13122348? ago 

On any pluggable interface, the cables are meant to fail first. It is much easier to replace a cord than to replace an internal port.

0
0

[–] i_scream_trucks ago 

I havent had this issue for years.

Used to get the plastic cylinders on inside of the charging port split and then youd end up not being able to plug it in but luckily we have had a dude with his own electronics workshop in his garage thats been repairing shit like that for 2 decades in the next suburb over. If he couldnt re solder it he would get you a replacement board and fix it at cost.

Also asian :) awesome feller. To this day i want to go work for him.