[–] [deleted] 1 point -1 points (+0|-1) ago 

[Deleted]

1
0

[–] heygeorge [S] 1 point 0 points (+1|-1) ago 

I was thinking oil, too. I have a can of cutting oil that would stick better. I just haven't seen any backup of that... Everything I found online says water.

0
1

[–] ShittyAdvice 0 points 1 point (+1|-0) ago 

Forget the screws and just epoxy the boxes in place. You can find the right grade of epoxy in Kevdude's dildo drawer.

0
0

[–] heygeorge [S] ago 

Poor reading comprehension. Thread necro. You will be benned.

0
1

[–] jasonjohncowart 0 points 1 point (+1|-0) ago 

Before you mark your spot, put a piece of blue painters tape over the area where you are going to drill. Then mark your support Andrew. The tape will keep the edges from splintering. You will definitely need a diamond tipped blade as the gentleman said before

0
0

[–] heygeorge [S] ago 

Ah, good move on the tape.

Then mark your support Andrew

I don't know what this means exactly, but I assume you just meant to mark the spot.

0
0

[–] jasonjohncowart ago 

I do not know why it wrote support Andrew. I was dictating using Siri. What I meant is after you put your blue tape down, then mark your spot

[–] [deleted] 0 points 4 points (+4|-0) ago 

[Deleted]

0
3

[–] heygeorge [S] 0 points 3 points (+3|-0) ago 

Aren't there like 100 mods over there? Why do I have to do it?

[–] [deleted] 0 points 2 points (+2|-0) ago 

[Deleted]

0
4

[–] 8265179? 0 points 4 points (+4|-0) ago 

You need a 3/16" diamond drill bit. GO SLOW.

Amazon sells them.

0
6

[–] Artofchoke 0 points 6 points (+6|-0) ago 

Water and patience. 💖